![]() If the error is still not resolved, the Print Head may be damaged. If the Print Head is already installed, remove the Print Head once and then reinstall it. Inklevel on canon mg2922 install#Print Head is not installed./Print Head is defective.įollow the directions given in your setup manual to install the Print Head. The printer may be damaged if printing is continued under the ink out condition. ![]() Replace the empty ink tank immediately after the printing. Then printing can continue under the ink out condition. If printing is in progress and you want to continue printing, press the RESUME/CANCEL button with the ink tank installed. If the lamp on the ink tank is flashing, ink may have run out.Ĭlose the Top Cover after ink tank replacement to resume printing. Install an appropriate canon ink cartridge. If the lamp on the ink tank is not lit, the ink tank may not be installed properly. Ink tank is not installed properly./Ink may have run out. Remove the jammed paper, reload paper in the printer, and then press the RESUME/CANCEL button. If the error still remains when the Front Tray or the Front Feed Support is opened, paper may be jammed. If the Front Feed Support is closed when printing from the Front Tray, open it and press the RESUME/CANCEL button on the printer. Reload photo paper to the Rear Tray and press the RESUME/CANCEL button.įront Tray or Front Feed Support is closed./Paper jams. When the Power lamp flashes blue even though the printer is not in use, the printer is shaking the ink tanks. Load the paper correctly in the Front Tray and press the RESUME/CANCEL button on the printer. The printer is not ready to feed paper from the Front Tray yet. No support is available on this topic from us other than the below. When you have successfully disabled the status monitor, you will no longer get reports of empty cartridges when they still contain ink.THIS WEBSITE IS NOT CANON - It is an informational page provided by Red River Paper. If you have the status monitor open on your screen, you should see yellow exclaimation marks (status monitor thinks there is a problem) change to red crosses (status monitor off), like this: ![]() The printer will usually beep to acknowledge, but this varies from model to model.ĭepending on your printer model, you may need to turn it off and on again for this to be registered, and you may also need to repeat the process for each cartridge. The symbol is always the same though, it's a red circle enclosing an inverted triangle:Īll you need to do is to hold this button down for 5-10 seconds. First, locate the button that will do this - it's on the front panel of the printer and may be marked "STOP", "RESUME", "CLEAR", "RESET" or any combination of these. ![]() The easiest fix is to turn off the status monitor. Older models have a numeric error report, you may see the error codes U162, U163, E005, or 1401 - there are others, this advice refers to any error that your manual informs you is related to ink levels. You may see a graphic representation on your screen that looks something like this: This can sometimes prevent printing altogether. The Canon status monitor is unusually difficult to work with, and will often report cartridges as empty or low on ink when they have just been replaced. Inkjet printers do not contain any mechanism to measure the amount of ink left in a cartridge - any values that the printer or status monitor give you are estimates based the number of pages printed since the cartridge was last changed. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |